Removing flywheel
Preliminary work
- Disconnecting all battery GROUND LEADS .
- Remove the center UNDERBODY PROTECTION .
- Remove rear UNDERBODY PROTECTION .
- Remove the side transmission UNDERBODY PLANKING .
- Remove left and right tank COVER .
- Remove the tunnel connecting SUPPORT .
- Remove EXHAUST SYSTEM .
- Remove STARTER MOTOR .
- Remove the HEAT SHIELDS .
- Remove the RETAINING PLATES .
- Partially loosen the PROP SHAFT .
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
- Fasten the flywheel with the special tool 0 493 938 (11 9 260) and tighten with the special tool 0 494 130 (11 9 264) .
- Release the screws (1) to (8).NOTE: RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information, see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
- Feed out the pulse wheel (1) and remove.
- Protect the pulse wheel (1) in a plastic bag from shavings.
- The pulse wheel (1) is magnetic, place the pulse wheel (1) in the correct position.