Installing loading edge trim

• Check clamps (1) for damage; replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed the loading edge trim (1) under the sealing lip of the trunk lid seal.
• Fit the trim of the loading edge (1) at the detents (2) and clip it in to the bottom.
• Engage expanding rivet (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR LUGGAGE COMPARTMENT WELL .
• Refer to INSTALLING BOTH BOTTOM D-PILLAR TRIM PANELS .
• Refer to INSTALLING BOTH FLAPS IN THE LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .