Installing rear brake hose
- Attach and tighten brake hose (2) on brake caliper.
Never twist brake hose and avoid all contact with components attached rigidly to the body!
TIGHTENING TORQUE SPECIFICATIONS
| Brake hose to brake caliper, rear | ||
| Tightening torque | 24 Nm | |
- Attach the brake hose in the brackets (1).
- Attach and tighten union screw (1).
Hold on to square shaft, if necessary (2).
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR BRAKE FLUID .