Disconnecting the bleeder unit for brake fluid

• Switch off bleeder unit (1) and remove from brake fluid expansion tank.
• Check the brake fluid level; if necessary, adjust to maximum mark.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the seal (1) of sealing cap for damage and replace it if necessary.
• Mount the sealing cap on the brake fluid expansion tank.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Installing front windshield panel cover 

• Guide in and install the front fairing panel cover (2) in the rear fairing panel cover (3).

• Ensure the front fairing panel cover (2) is seated correctly.
• Secure expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the rear hood seal 

• Install the hood seal (1) and make sure it has a correct fit.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PERFORM THE CBS RESET .
• Refer to IF INSTALLED: CHECKING THE GAS PRESSURE SPRINGS FOR HOOD (ONLY FOR VERSIONS WITH ACTIVE PEDESTRIAN PROTECTION (SA8TF)) .