Install front brake hose
- Fit and tighten brake hose (1) on brake caliper.
If necessary, grip at knurling (2).
Never twist brake hose and avoid all contact with components attached rigidly to the body!
TIGHTENING TORQUE SPECIFICATIONS
| Brake hose to brake caliper, front | ||
| Tightening torque | 24 Nm | |
- Attach the brake hose in the brackets (3).
- Attach and tighten union screw (1).
Hold on to square shaft, if necessary (2).
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR BRAKE FLUID .