Remove rear window
NOTE:
TECHNICAL INFORMATION
The following procedure forms the basis for these repair instructions and must be observed without fail.
For additional information see: GENERAL PROCEDURE FOR THE DISASSEMBLY AND INSTALLATION OF BONDED WINDOW GLASS .
The following procedure forms the basis for these repair instructions and must be observed without fail.
For additional information see: GENERAL PROCEDURE FOR THE DISASSEMBLY AND INSTALLATION OF BONDED WINDOW GLASS .
NOTE:
TECHNICAL INFORMATION
Perform window removal using the "spider".
For additional information see: REMOVING WINDOWS WITH A "SPIDER" .
Perform window removal using the "spider".
For additional information see: REMOVING WINDOWS WITH A "SPIDER" .
Preliminary work
- Refer to REMOVING THE TRIM FOR THE TOP REAR WINDOW FRAME .
- Refer to REMOVING BOTH TRIMS FOR THE REAR WINDOW FRAME ON THE SIDE .
- Refer to REMOVING THE TAILGATE TRIM PANEL .
- Refer to REMOVING REAR SPOILER .
- Refer to REMOVING THE LOWER SECTION OF THE REAR SPOILER .
- Refer to REMOVING WINDSCREEN WIPER ARM OF THE REAR WIPER .
- Refer to REMOVING REAR WINDOW WIPER MOTOR .
- Loosen screws (1).
- Unlock and disconnect the plug connections (2) and unclip from the cable clips.
- Secure cable (1) to rear window with adhesive tape.
- Tape off body in area of piercing point with fabric adhesive tape.
- Slide the thread along the line (1) through the adhesive bead (2) from the inside.
- Cut out the rear window with the spider.