Installing rail on bank 2

• Position high pressure rail.
• Manually tighten the screws (1)  as far as they will go.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Manually tighten the screws (1)  as far as they will go.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (2)  on the high pressure pump with the special tool 0 491 277 (13 5 020) .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Fuel supply line/rail to high pressure pump
  Nut	tightening torque	30 Nm

• Tighten nuts (1)  on the injectors with the special tool 0 495 908 (37 1 150)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  High-pressure rail to injectors
  Nuts	Tightening torque	25 Nm

• Position high pressure rail.
• Tighten down screws (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rail to cylinder head cover
  M6x25 screw	Tightening torque	10 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Hold-down device to cylinder head cover
  screw	Tightening torque	13 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position ground cable (2)  .
• Tighten nuts (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Ground cable to hold-down device
  Nuts	Tightening torque	5.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE IGNITION COILS OF CYLINDER BANK 2 .
• Refer to INSTALLING CONDUIT ON BANK 2 .
• Refer to ATTACHING COOLANT EXPANSION TANK .
• Refer to INSTALLING THE HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
• Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .