Installing the holder of the DME control unit for cylinders 5 to 8

• Carefully push the holder of the refrigerant line (3)  aside.
• Insert holder with the DME control unit of cylinders 5 to 8 (2)  and position.
• Engage the connector bracket (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Ensure that the centering pin (2)  is located in the lug (1)  on the left spring support.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Engage the cable bracket (1)  .
• Tighten down screw (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.
• Snap the cable bracket (2)  into the adapter plate.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
• Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .