Installing LED fan
- Feed in the guide from the LED fan (1)
into the intake (2)
.
- Attach and lock the connector (2)
from the LED fan (1)
.
Ensure correct cable routing in the headlight (3) .
- Check the seal (1)
of the cover (2)
for damage and replace if necessary.
- Position the cover flap (2) on the headlight.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Cover cap to headlight Screw tightening torque 1.5 Nm
Follow-up work
- Refer to INSTALLING HEADLIGHT .
- Refer to INSTALLING TOPPING AIR DUCT .
- Refer to INSTALLING FRONT BUMPER COVER .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH COVERS .
- Refer to INSTALLING CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to ADJUSTING HEADLIGHTS .