Removing and installing/replacing airbag unit (sport steering wheel) (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with SAFETY REGULATIONS for handling components with gas generators.
- Do not exert any force on the airbag unit.
- Use only specified release tool for the airbag unit.
NOTE:
Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT:
STEERING WHEEL must be replaced if airbag unit has been triggered!
Follow procedure after AIRBAG DEPLOYMENT .
Follow procedure after AIRBAG DEPLOYMENT .
NOTE:
Necessary preliminary tasks:
- Disconnect BATTERY EARTH LEAD .
Insert Torx screwdriver T20 (1) vertically into the concealed opening until limit position (2) can be felt.
Pull Torx screwdriver (1) approx. 2-3 mm out of opening. Press screwdriver handle carefully towards middle of steering wheel and simultaneously slide into opening in order to position the Torx screwdriver behind retaining spring bracket (refer to graphic below).
IMPORTANT:
Press Torx screwdriver carefully towards the middle of steering wheel and slide it in again! Pushing the Torx screwdriver too much further in the direction of steering wheel center will lead to damage of the steering wheel trim/the steering wheel.
Press retaining spring bracket (1) of airbag unit inwards and simultaneously pull airbag unit upwards until it unlocks.
Repeat procedure on other side.
NOTE:
Installation note:
Carefully push airbag unit in direction of steering column shaft into steering wheel with uniform pressing force until airbag engages noticeably and audibly.
Carefully push airbag unit in direction of steering column shaft into steering wheel with uniform pressing force until airbag engages noticeably and audibly.
WARNING:
Danger of injury!
The airbag unit may only be set down with the airbag itself facing up .
The airbag unit may only be set down with the airbag itself facing up .
Tilt airbag unit forwards.
Disconnect plug connections (1) and remove airbag unit.
NOTE:
Installation note:
Make sure electrical leads are correctly positioned.
Make sure electrical leads are correctly positioned.