Install the front top cross connection
- Attach the front top cross connection (4).
- Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Front reinforcement strut screw Replace screws. Tightening torque 19 Nm - Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Top front cross connection to hood lock support screw Tightening torque 11.8 Nm - Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Front Y-strut to cross connection and/or bumper bracket M6x20 screw Tightening torque 11.8 Nm - Mount the expanding rivets (1).
Follow-up work
- Refer to INSERT TOPPING AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING BOTH HEADLIGHTS .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .