Removing wiring harness section for the ignition system of cylinder bank 1
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE CONTROL UNIT BRACKET FOR CYLINDERS 1 TO 4 .
- Refer to REMOVAL OF EXPANSION TANK FOR CHARGE AIR COOLERS (PARTIAL REMOVAL) .
- Refer to DISCONNECTING THE PLUG CONNECTIONS OF THE INJECTORS OF CYLINDER BANK 1 .
- Refer to DISCONNECTING PLUG CONNECTIONS OF THE IGNITION COIL OF CYLINDER BANK 1 .
- Loosen nut (3).
- Loosen screws (2).
- Disconnect the wiring harness section from the holders (4).
- Release cable section from the holders (1).
- Unfasten nut (1).
- Feed out ground cable and remove.