Install the intake camshaft sensor of cylinder bank 2

Checking the sealing ring on the camshaft position sensor 

Check 

• Check the O-ring (1) on the camshaft position sensor for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» O-ring (1) damaged

Measure

• Replace O-ring (1).

Parts:  O-ring

Result 

» O-ring (1) not damaged.

Measure

• Continue the repair in the next step.

• Coat O-ring on the camshaft position sensor with motor oil.
• Position the intake camshaft sensor of cylinder bank 2 (1).
• Tighten down screw (2).

Camshaft position sensor
M6x16 screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
• Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
• Refer to CONNECTING BATTERY GROUND LEAD .