Installing rail on bank 2

• Position high pressure rail.
• Manually tighten the screws (1) as far as they will go.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Manually tighten the screws (1) as far as they will go.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (2) on the high pressure pump with the special tool 0 491 277 (13 5 020) .

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1) on the injectors with the special tool 0 495 908 (37 1 150)  .

• Position high pressure rail.
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position ground cable (2). Tighten nuts (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE IGNITION COILS OF CYLINDER BANK 2 .
• Installing conduit on bank 2.

  Courtesy of BMW OF NORTH AMERICA, INC.

  • Clip the wiring harness (2) into the clamps (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  • Position the wiring harness.
  • Tighten down screws (1).
    TIGHTENING TORQUES
    
    

    Cable duct
    M6x16 screw	Tightening torque	10Nm

• Refer to ATTACHING COOLANT EXPANSION TANK .
• Refer to INSTALLING HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
• Installing the cover panel of the master DME control unit.

  Courtesy of BMW OF NORTH AMERICA, INC.

  • Position the cover of the master DME control unit (1)
  • Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to CONNECTING BATTERY GROUND LEAD .