Removing module bracket on the rear door

Preliminary work 

• Refer to REMOVING THE WINDOW CHANNEL STRIP FROM THE REAR DOOR .
• Refer to REMOVING THE COVER ON THE DOOR HANDLE .
• Refer to REMOVING THE REAR DOOR TRIM PANEL .

• Secure the side window glass to the door frame when it is closed using adhesive tape.
• Spread apart the holder on the outside of the side window glass with the special tool  0 496 569 (00 9 325)  until the side window glass can be detached, 
• Shift power windows down by approximately 10 cm.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Detach wiring harness (1) and disconnect plug connections.
• Release snap fastener (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Thread off the module bracket completely with the power windows.

  Courtesy of BMW OF NORTH AMERICA, INC.