Replacing the module bracket on the front door
WARNING:
Working on 12 V electrical system
.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING FRONT DOOR TRIM PANEL .
- Refer to REMOVING THE MODULE BRACKET FROM THE FRONT DOOR .
- Loosen screws (1).
- Remove the speaker (2).
- Turn the sensor (1) in arrow direction and remove it.
- Replace the module bracket.
Parts: Module bracket
- Position the sensor (1) and turn it in arrow direction and lock it.
- Position the speaker (2) and tighten the screws (1).TIGHTENING TORQUE SPECIFICATION
Loudspeaker on door Screw tightening torque 2 Nm
Follow-up work
- Refer to INSTALLING THE MODULE BRACKET ON THE FRONT DOOR .
- Refer to INSTALLING FRONT DOOR TRIM PANEL .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .