Replacing the trim of the start-stop button

Preliminary work 

• Refer to DEACTIVATING THE 48V ELECTRICAL SYSTEM .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to REMOVING THE CENTER ARMREST STORAGE COMPARTMENT TRIM .
• Refer to REMOVING THE CENTER CONSOLE TRIM .
• Refer to REMOVING THE OPERATING FACILITY IN THE CENTER CONSOLE .
• Refer to REMOVING THE IDRIVE CONTROLLER .
• Refer to REMOVING THE HDC BUTTON/TRIM .
• Refer to REMOVING THE SELECTOR LEVER .
• Refer to REMOVING TRIM PANELS ON THE OPERATING FACILITY IN THE CENTER CONSOLE .

removing the trim of the start-stop button 

• Release all detents (1)  and remove the trim from the start-stop button (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the start-stop button trim.

  Parts:  the start-stop button trim

installing start-stop button trim 

• Position trim (2)  on the start-stop button and engage it.

  All retaining lugs (1)  must audibly snap into place.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIMS ON THE OPERATING FACILITY IN THE CENTER CONSOLE .
• Refer to INSTALLING THE SELECTOR LEVER .
• Refer to INSTALLING THE HDC BUTTON/TRIM .
• Refer to INSTALLING THE IDRIVE CONTROLLER .
• Refer to INSTALLING THE OPERATING FACILITY IN THE CENTER CONSOLE .
• Refer to INSTALLING THE CENTER CONSOLE TRIM .
• Refer to INSTALLING TRIM IN STORAGE COMPARTMENT OF CENTER ARMREST .
• Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48V ELECTRICAL SYSTEM .