Installing the wishbone
- Position the wishbone (2) on the swivel bearing (3).
- Replace nut (1).
Parts: Nut
- Tighten nut (1). If necessary, counter support at the Torx socket.
TIGHTENING TORQUE SPECIFICATION
| Wishbone to swivel bearing | ||
|---|---|---|
| M14 Replace nut. |
tightening torque | 175 Nm |
NOTE:
TECHNICAL INFORMATION
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.
- Position the wishbone (3) on the front subframe.
- Replace the screw (2) and the nut (1).
Parts: Screw, nut
- Insert screw (2) and guide on the nut (1).
- Tighten screw (2) by hand. In doing so, counter support at the nut (1).
Follow-up work
- Refer to FASTENING THE RIDE HEIGHT SENSOR ON THE BOTTOM WISHBONE .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to MEASURING THE RIDE HEIGHT OF THE FRONT AXLE AND ADJUSTING THE NORMAL POSITION .
- Refer to TIGHTENING THE SCREW CONNECTION OF THE WISHBONE ON THE FRONT SUBFRAME .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to PERFORM CHASSIS ALIGNMENT CHECK .