Replacing lock cylinder
WARNING:
Working on 12 V electrical system.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING FRONT DOOR TRIM PANEL .
- Refer to REMOVING THE MODULE BRACKET FROM THE FRONT DOOR .
- Refer to REMOVING OUTER WINDOW CHANNEL STRIP .
- Refer to RELEASING THE FRONT DOOR WINDOW GLASS .
- Refer to REMOVING FRONT DOOR WINDOW GLASS .
- Refer to PARTIALLY REMOVING ELECTRICAL POWER WINDOW OF THE FRONT DOOR .
- Refer to REMOVING THE OUTSIDE DOOR HANDLE .
- Refer to REMOVING THE OUTSIDE DOOR HANDLE SUPPORT .
- Unclip the cover (1) at the points (2).
- Remove cover panel (1).
- Detach the locking rod (1).
- Twist the lock cylinder (2) in clockwise direction and remove it.
- Replace the lock cylinder.
Parts: lock barrel
- Screw in the lock cylinder (2) counterclockwise.
- Hook the locking rod (1) into the lock cylinder (2).
- Clip in the cover (1) in the points (2).
Follow-up work
- Refer to INSTALLING THE OUTER DOOR HANDLE SUPPORT .
- Refer to INSTALLING THE OUTSIDE DOOR HANDLE .
- Refer to INSTALLING SOME OF THE WINDOW REGULATORS WINDOWS IN THE FRONT DOOR .
- Refer to INSTALLING FRONT DOOR WINDOW GLASS .
- Refer to INSTALLING THE MODULE BRACKET ON THE FRONT DOOR .
- Refer to INSTALLING FRONT DOOR TRIM PANEL .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to ADJUSTING DOOR WINDOW GLASS .
- Refer to INSTALLING OUTER WINDOW CHANNEL STRIP .