Install the bottom deformation element
- Feed in the deformation element (2) .
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Deformation element, bottom to adapter, front axle support M 10x60 screw Tightening torque 40 Nm
Follow-up work
- Refer to INSTALLING SUPPORT FOR BUMPER COVER AT FRONT BOTTOM .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT AIR DUCT .
- Refer to FASTENING THE LEFT AND RIGHT EXTERNAL RADIATOR .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .