Install support for bumper cover at front bottom
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Thread in the support for the bumper cover at front bottom (2) and position.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Support for front bottom bumper cover to deformation element Combination oval-head machine screw tightening torque 10 Nm
Follow-up work
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT AIR DUCT .
- Refer to FASTENING THE LEFT AND RIGHT EXTERNAL RADIATOR .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .