Installing high pressure pump

• Feed in and install high pressure pump (2)  .
• Replace the bolts (arrows).

  Parts:  Screws

• Position the screws (arrows) on the high pressure pump (2)  and alternately  tighten in increments of 90°  .

  Compliance with this specification is imperative to make sure that the piston will not break due to twisting.

  TIGHTENING TORQUES SPECIFICATION
  
  

  High pressure pump to cylinder head cover
  M6X25	Replace screws.
  	Tightening torque	12 Nm

• Connect and lock the connector (1)  .

  The connector (1)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE HIGH-PRESSURE LINE BETWEEN THE HIGH-PRESSURE RAIL AND THE HIGH-PRESSURE PUMP .
• Refer to INSTALLING FUEL DELIVERY LINE .
• Refer to INSTALLING THE IGNITION COILS .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING THE TENSION STRUT ON THE STRUT TOWER .
• Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE FIREWALL UPPER PART .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING INTAKE SILENCER HOUSING .