Securing the front active stabilizer
- Correctly align the left and right rubber mounts (1) with the upper sections of the anti-roll bar bracket.
- Carefully lift the active stabilizer (2) with the universal jack 0 490 133 (00 2 030) .
- Unscrew the left and right screw (3).
NOTE:
RISK OF DAMAGE
Improper screw length can cause component damage.
The use of screws of improper length can lead to component damage.
Improper screw length can cause component damage.
The use of screws of improper length can lead to component damage.
- Note the correct screw length.
- Install screws that correspond to the original length.
- Position both upper sections of the anti-roll bar bracket and the left retainer (4) on the active stabilizer.
- Replace screws (2) and (3).
Parts: Screws
- Tighten down screws (2) and (3).
Screws (2) = M12x89
Screws (3) = M12x50
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | ||
|---|---|---|
| M12 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |
- Lower the universal jack and put it away.