Installing the engine on the assembly jig

CAUTION: Heavy component. 
Heavy components can lead to injury or damage. 

• Remove and install heavy components with the aid of another person/other persons.

• Get the set of special tools 0 495 187 (00 2 300) ready.

  Number	Description
  1	Assembly jig
  2	Flange
  3	Crank
  4	cover panel
  5	shelf
  6	Rear shaped part
  7	Collection pan
  8	Front shaped part
  9	Front wheel
  10	Rear wheel with stop
  11	Mat

  Courtesy of BMW OF NORTH AMERICA, INC.

• Have the special tool 2 411 718  ready.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the assembly jig 0 495 187 (00 2 300) with the special tool 0 495 196 (00 2 320)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (arrows).

TIGHTENING TORQUE SPECIFICATIONS

Special tool 00 2 320 to special tool 00 2 300
M14X95	Tightening torque	130 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Screw the special tool 2 413 082  to the 0 495 196 (00 2 320)  special tool.
• Tighten the screws (arrows).

TIGHTENING TORQUE SPECIFICATIONS

Special tool 2 413 082 to special tool 00 2 320
M12x65	Tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Position and secure the special tool (motor mount) 2 411 718  on the engine.
• Tighten the screws (marks).

TIGHTENING TORQUE SPECIFICATIONS

Special tool 2 411 718 to crankcase
M10x30	tightening torque	38 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Slowly lower the engine.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Ensure that special tool 2 411 718  engages in special tool 2 413 082  .
• Hand-tighten nuts (1).

  The clamping jaws must make full contact.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release both hooks of the special tool (lifting equipment) 0 490 567 (11 0 020) at the front and rear of the engine from the mounting brackets.
• Remove the workshop crane 2 220 718 .

Courtesy of BMW OF NORTH AMERICA, INC.