Removing the cylinder head from the assembly jig

CAUTION: Heavy component. 
Heavy components can lead to injury or damage. 

• Remove and install heavy components with the aid of another person/other persons.

• Loosen screw (2)  .
• Feed out rod (1)  in arrow direction and set aside.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the screws (1) from the special tool 0 494 150 (11 9 440). 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Stage the special tool (workshop crane) 2 220 718 .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Prepare the special tool 0 490 567 (11 0 020) .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and position special tool 0 490 567 (11 0 020) on the cylinder head (1)  .
• Position the workshop crane 2 220 718 and connect it to special tool 0 490 567 (11 0 020) .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Detach the cylinder head (1)  with the workshop crane 2 220 718 and special tool 0 490 567 (11 0 020) from the device (2)  , guide it out and remove.

Courtesy of BMW OF NORTH AMERICA, INC.