Connect the coolant lines for the low-temperature coolant circuit
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Check the sealing rings (1) of the coolant lines (2) for damage and replace them if necessary.
- Connect and lock the coolant line (1) on the air conditioning condenser.
The coolant line (1) must audibly engage.
- Connect the coolant line (1) to the electric coolant pump and lock it.
The coolant line (1) must audibly engage.
Follow-up work
- Refer to INSTALLING THE FRONT BOTTOM LEFT AND RIGHT COVER .
- Refer to INSTALLING FRONT STIFFENING PLATE AND/OR UNDERBODY PROTECTION OF THE STEERING GEAR .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE RIGHT FRONT-END STRUT .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .