Install fan cowl
- Feed in and install the fan cowl (3) in the direction of the arrow.
- Tighten the screws (2).
TIGHTENING TORQUES SPECIFICATION
| Fan cowl on radiator | ||
|---|---|---|
| TS6x20 | Tightening torque | 6 Nm |
- Connect and lock the connector (1).
The connector (1) must engage audibly.
- If fitted:
Fasten the coolant line (1) below at the fan cowl with the clamps.
- Feed in and install coolant line (2).
- Lock clamps (1).
The clamps (1) must engage audibly.
Follow-up work
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE RIGHT FRONT-END STRUT .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .