Installing the rubber mount for the camber control arm

• Position the rubber mount on the rear axle support with the special tool 2 412 613  .
  NOTE: Align the slot on the rubber mount vertically downwards.
• Pull in the rubber mount with special tools 2 412 613, 0 496 609 (33 0 163), 0 496 505 (33 0 026)  and 0 496 506 (33 0 027) to the stop.
  NOTE: Adherence to the installation direction is absolutely mandatory.

  The rubber mount is inserted in the direction of travel (F).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE CAMBER CONTROL ARM .
• Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM .
• Refer to PERFORM CHASSIS ALIGNMENT CHECK .