Installing spray nozzle for the Night Vision camera

• Position the spray nozzle (2) on the cover (3) and tighten the screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Spray nozzle on cover
  Screw	tightening torque	2.0 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in the front cover (2) of the night vision camera on the guide (3) and install it.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Holder, BMW Night Vision to trim
  Screw	tightening torque	3.3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the back cover (1) of the night vision camera in the direction of the arrow on the guides (2) and (3) and install it.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screw (1) on the holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE NIGHT VISION CAMERA .
• Refer to INSTALLING THE TOP AIR FLAP CONTROL .
• Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
• Refer to INSTALLING FRONT BUMPER COVER .
• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH COVERS .
• Refer to INSTALLING CENTER RADIATOR GRILLE .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to ADJUSTING NIGHT VISION CAMERA .