Removing the spray nozzle for the night vision camera
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to REMOVING CENTER RADIATOR ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING BOTH WHEEL ARCH COVERS IN FRONT .
- Refer to PARTIALLY REMOVING TEMPERATURE SENSOR .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to REMOVING THE FRAME OF THE UPPER AIR FLAP CONTROL .
- Refer to REMOVING THE NIGHT VISION CAMERA .
- Unscrew screws (1) on the holder (2).
- Feed out the back cover (1) from the night vision camera in the direction of the arrow out of the guides (2) and (3) and remove it.
- Loosen screws (1).
- Guide out the front cover (2) of the night vision camera on the guide (3) and remove it.
- Loosen screw (1).
- Remove the spray nozzle (2) from the cover (3).