Installing the positive battery cable from the remote positive terminal to the starter

• Insert and position the positive battery cable (3).
• Replace the cable ties (2).

  Parts:  Cable tie

• Tighten the cable tie.
• Cut off the protruding end of the cable ties.
• Engage the positive battery cable (3) on the holder (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Battery positive lead to starter
  Nut M8	Tightening torque	13.4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the plug connection (1) on the solenoid switch and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the positive battery cable (3) on the stud bolt of the remote positive terminal.
• Engage the positive battery cable (3) on the holder (2).
• Tighten nut (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Positive battery cable
  Positive pole screw	tightening torque	15 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the cover (1) in a downwards direction.
• Check the detents (2) are seated correctly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
• Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .