Install the knock sensors on the right
Precondition
Ignition is switched off.
The vehicle battery is disconnected.
NOTE:
TECHNICAL INFORMATION
When installing the knock sensors, the tightening torque must be observed.
Non-compliance with the tightening torque can lead to malfunction.
When installing the knock sensors, the tightening torque must be observed.
Non-compliance with the tightening torque can lead to malfunction.
- Clean the contact surfaces of the knock sensors at the cylinder head.
- Position the knock sensors and secure them with bolts (3).
- Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Knock sensor to crankcase M8x30 tightening torque 21.4 Nm - Connect connectors (2) and lock.
The connectors (2) must engage audibly.
- Mount the clamp (1) on the intake plenum.
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .