Removing the spring strut from the coil spring
WARNING:
Spring preload.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Secure the coil spring with special tool 2 213 022 (31 3 340).
- Use special tool as per Owner's Manual and always observe the safety instructions.
Preliminary work
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE REAR LEFT OR RIGHT .
- Refer to REMOVING THE LATERAL HOOD SEAL .
- Refer to PARTIALLY DETACHING THE FRONT SPRING STRUT .
- Refer to REMOVING FRONT LEFT OR RIGHT WHEEL .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to DETACHING THE UPPER WISHBONE FROM THE SWIVEL BEARING .
- Refer to SECURING THE SWIVEL BEARING .
- Refer to REMOVING THE SPRING STRUT HOLDER .
- Refer to REMOVING SPRING STRUT .
- Refer to PREPARING THE SPRING TENSIONER .
- Refer to TENSIONING THE COIL SPRING .
- Refer to REMOVING THE SPRING STRUT SUPPORT BEARING .
- Remove the spring strut (1) with the auxiliary damper, the protective tube and the spring pad from the tensioned coil spring (2) .
- Pull the auxiliary damper, the protective tube and the spring pad off of the spring strut (1) .