Install front engine encapsulation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine encapsulation (1).
- Correctly route the wiring harness (3) and clip it in at the highlighted areas.
- If necessary, position the ground cable and secure it with the screw.
TIGHTENING TORQUES SPECIFICATION
| Front ground cable to cylinder head | ||
| M6 | tightening torque | 8 Nm |
- Connect connectors (1) and (2).
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Connect the ventilation line (2) with the intake plenum.
- Connect the ventilation line (1) with the tank vent valve and clip it in at the highlighted area.
Follow-up work
- Refer to INSTALLING CLEAN AIR PIPE, TOP .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .