Installing the seal for the windshield panel

• Place the seal for the windshield panel (1) on the metal insert (2).
• Make sure the lug of the seal (3) is correctly positioned in the recess of the metal insert (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove seal for the windshield panel (2).
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Windshield panel Gasket to front strut
  Screw	tightening torque	1.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Thread in seal for the windshield panel (1) on both shanks of the supports (2).
• Ensure that the seal (1) is positioned in the marked areas correctly on the support (2) in order to prevent water ingress.
  NOTE: If Necessary, coat the seal lightly with water to make installation easier.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE WINDSHIELD PANEL TRIM .
• Refer to ADJUSTING DOOR WINDOW GLASS .
• Refer to ADJUSTING THE REAR SIDE WINDOW .