Installing the switch for the convertible top operation
- Position the switch for actuating the convertible top (2)
at the gear selector switch (GWS) (3)
.
The detents (arrows) must engage audibly.
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Switch for actuating the convertible top on gear selector | ||
|---|---|---|
| Screw | tightening torque | 1.8 Nm |
Follow-up work
- Refer to INSTALLING THE DECORATIVE TRIM ON THE CENTER CONSOLE .
- Refer to INSTALLING THE CENTER OF THE VENTILATION GRILLE WITH THE INTEGRATED AIR CONDITIONING CONTROL PANEL .
- Refer to INSTALLING THE CENTER STACK MODULE .
- Refer to INSTALLING THE WIRELESS CHARGING STORAGE .
- Refer to INSTALLING THE CUP HOLDER .
- Refer to INSTALLING THE CENTRAL INFORMATION DISPLAY (CID) .
- Refer to INSTALLING THE SPEAKER TRIM AT THE DASHBOARD .
- Refer to INSTALLING CENTER ARMREST .
- Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .