If installed: Remounting the driver camera system (DCS)

Removing the driver camera system (DCS) 

• Release the screws (1) on the Driver Camera System (DCS) (2).
• Feed out and remove the Driver Camera System (DCS) (2) upwards at the guides (3) of the instrument cluster (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

  Installing the driver camera system (DCS) 

• Feed the Driver Camera System (DCS) (2) into the guides (3) of the instrument cluster (4) from the top.
• Tighten the screws (1) on the Driver Camera System (DCS) (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Driver Camera System (DCS) on instrument cluster
  Screw	tightening torque	1.05 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INSTRUMENT CLUSTER (KOMBI) .
• Refer to INSTALLING STEERING COLUMN SHROUD LOWER SECTION .
• Refer to FITTING STEERING COLUMN SHROUD UPPER SECTION .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to INSTALLING THE STEERING COLUMN SWITCH CLUSTER (SZL) .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .