Attaching the wheel arch connection (national-market vehicle for China)
NOTE:
Perform the steps on the left and right side.
NOTE:
TECHNICAL INFORMATION
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
- Clean the bumper cover (1) in the area (2).
TECHNICAL DATA SPECIFICATION
| Air drying time after cleaning | |
|---|---|
| Cleaning agent R2 | 2 min |
CONSUMABLE SPECIFICATION
| Cleaning agent R2 | 500 ml | 83190417324 |
NOTE:
TECHNICAL INFORMATION
Bonding at room and object temperature of >+18°C
Bonding at room and object temperature of >+18°C
- Pull the protective film off the wheel arch connection (1).
- Position the wheel arch connection (1) parallel to the front edge and flush with the upper edge of the bumper cover.
- Press the wheel arch connection (1) on over the entire adhesive area by applying firm pressure with a thumb.
Prepare bonding with adhesive K6
NOTE:
TECHNICAL INFORMATION
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
- Clean adhesive area and allow to dry.
TECHNICAL DATA SPECIFICATION
| Air drying time after cleaning | |
|---|---|
| Cleaning agent R2 | 2 min |
CONSUMABLE SPECIFICATION
| Cleaning agent R2 | 500 ml | 83190417324 |
- Brush adhesive area with primer and allow to dry.
TECHNICAL DATA SPECIFICATION
| Air drying time after the order | |
|---|---|
| Loctite SF 770 | 30 s |
- Apply adhesive all over.
ADHESIVE SPECIFICATION
| Adhesive set K6 | 11 g, Loctite 3090 | 83195A547C4 |
| 10 g, Loctite SF 770 | ||
| 2, Mixing tube |
- Use adhesive to attach the wheel arch connection in the accessible area.
ADHESIVE SPECIFICATION
| Adhesive set K6 | 11 g, Loctite 3090 | 83195A547C4 |
| 10 g, Loctite SF 770 | ||
| 2, Mixing tube |
Follow-up work
- Refer to INSTALLING BOTH REAR REFLECTORS .
- Refer to INSTALLING THE COVER OF THE TOWING EYE .
- Refer to INSTALLING REAR BUMPER PANEL .
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .