Installing the 48 V battery
TIGHTENING TORQUE SPECIFICATIONS
| Battery tray to body | ||
| M8 screw | tightening torque | 19 Nm |
- Install the cover (2) .
The detents (1) must engage audibly.
- Tighten the screws.
TIGHTENING TORQUE SPECIFICATIONS
| Battery tray to body | ||
| M6 screw | tightening torque | 8 Nm |
- Install cover caps (1)
by turning.
- Check the seals of the coolant flange for damage, replace if necessary.
- Position the coolant connection.
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Coolant flange screw | ||
| Screw M6x20 | tightening torque | 8 Nm |
- Remove disconnection tool (2) from the coolant lines (1) .
WARNING:
Incorrect screw connection of the positive battery cable.
Risk of fire!
Risk of fire!
- Ensure that the positive battery cable is screwed with the correct nut.
- Position battery positive cable (2) on the 48 V battery (3) .
- Tighten nut on positive battery cable (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to 48-V battery | ||
| Nut M8 | tightening torque | 19 Nm |
- Mount positive terminal cover (1)
Follow-up work
- Refer to INSTALLING THE TENSION STRUT ON THE RIGHT SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ENCODE/PROGRAM CONTROL UNIT(S) .
- Refer to REGISTER BATTERY CHANGE .