Replacing the LED module for the left daytime driving lights
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .
Preliminary work
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING HEADLIGHT .
- Loosen screws (1).
- Pull LED module (2) out of headlight.
- Unlock connector (1) at LED module (2) and disconnect it.
- Check the seal (1) on the LED module (2) for damage and replace as needed.
- Replace the LED module for the daytime driving lights.
Parts: LED module for the daytime driving lights
- Connect connector (1) to LED module (2).
- Position the LED module (2) in the headlight.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| LED module of daytime running lights | ||
| Screw | tightening torque | 1.5 Nm |
Follow-up work
- Refer to INSTALLING HEADLIGHT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to ADJUSTING HEADLIGHTS .