Installing the support for the bumper cover

• Install bumper cover support (3)  and tighten the nuts (2)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Support, bumper, rear
  Nut	Tightening torque	108 Nm

• Replace nuts (1)  .

  Parts:  Nuts

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1)  .

Follow-up work 

• Refer to INSTALLING THE BOTTOM REAR BUMPER GUIDE .
• Refer to INSTALLING THE CONTROL UNIT FOR THE CONTACTLESS TRUNK OPENING .
• Refer to INSTALLING THE BOTTOM SENSOR LINE FOR THE CONTACTLESS TRUNK OPENING .
• Refer to INSTALLING TOPPING SENSOR LINE FOR CONTACTLESS TAILGATE OPENING .
• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING BOTH TRIM PIECES FOR THE EXHAUST TAILPIPE .
• Refer to INSTALLING THE TRIM ON THE REAR BUMPER PANEL .
• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL, LEFT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to ON VERSION WITH COMPACT SPARE WHEEL: INSTALLING THE STORAGE TRAYS .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .