Installing the holder for the Digital Motor Electronics control unit on the right

• Install the holder (2)  for the DME control unit on the right.
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure all cables (1)  on the holder for the DME control unit.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT FOR CYLINDERS 1 TO 4 .
• Refer to INSTALLING COVER FOR THE RIGHT DME CONTROL UNIT .
• Check the coolant level in the low-temperature coolant circuit and top up, if needed. Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .