Installing wiring harness section for ignition system of bank 2

Wiring harness section for the ignition system of cylinder bank 2

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and position the wiring harness section for the ignition system of cylinder bank (2) .
Position ground cable (2) .
Tighten nuts (1) .

TIGHTENING TORQUE SPECIFICATIONS

Ground cable to hold-down device
Nuts	Tightening torque	5.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Check all connectors (1) on the injectors again to ensure they are correctly fitted.
Check that all connectors are plugged in correctly.

Courtesy of BMW OF NORTH AMERICA, INC.

Install the ignition coils of cylinder bank 2

Precondition

Ignition is switched off.

NOTE: RISK OF DAMAGE
Damage to the ignition coil.
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil.

When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
Do not oil or grease the silicone tube of the spark plug socket. Do not use any protection or maintenance products (e.g. silicone spray, rubber care products, rust remover, etc.).

Feed in the ignition coils (2) and install them.
Tighten the screws (1) .

TIGHTENING TORQUE SPECIFICATIONS

Ignition coil
screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and install the cable clip (3) .
Tighten down screw (2) .

TIGHTENING TORQUE SPECIFICATIONS

Wiring harness on the cylinder head cover
M6x16 screw	Tightening torque	10 Nm
Nut M6	Tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten nut (1) .

TIGHTENING TORQUE SPECIFICATIONS

Wiring harness on the cylinder head cover
M6x16 screw	Tightening torque	10 Nm
Nut M6	Tightening torque	10 Nm

Connect and lock connectors (arrows).
The connectors (arrows) must audibly engage.
Feed the cable (2) into the bracket (arrows).
Secure clamps (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING COOLANT EXPANSION TANK .
Refer to INSTALLING THE CONTROL UNIT BRACKET FOR CYLINDERS 5 TO 8 .
Refer to INSTALLING CLEAN AIR PIPE, TOP .
Refer to INSTALLING THE COVER OF THE LEFT DME CONTROL UNIT .
Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
Refer to CONNECTING ALL BATTERY GROUND LEADS .