Installing control unit holder for cylinders 1 to 4

NOTE: RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.

Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
Read and comply with user information on using the associated special tool 12 7 060.
Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
For additional information see: NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .

NOTE: TECHNICAL INFORMATION
Follow instructions for removing and installing control units.
For additional information see: INSTRUCTIONS FOR REMOVAL AND REPLACEMENT OF CONTROL UNITS .

NOTE: TECHNICAL INFORMATION
If control units are disconnected, fault memory entries and functional limitations may occur.
The fault memory entries must be read out and, if necessary, deleted.

Feed in the control unit bracket (1) with the DME control unit in the brackets (2) and install.

Courtesy of BMW OF NORTH AMERICA, INC.
Lock the control unit holder (1) on the retaining tabs (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Connect the connector (3) with bracket (4) and lock.
The connector (3) must engage audibly.
Connect connectors (2) and lock.
The connector (2) must engage audibly.
Connect all connectors (1) and lock.
The connectors (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Fasten the clamps (arrows) to the control unit bracket (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the control unit bracket (2) with control unit.
Tighten the screws (1) .

TIGHTENING TORQUE SPECIFICATIONS

Control unit holder
Hexagon screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Fasten the clamps (3) on the bracket (4) .
Connect connectors (2) and lock.
The connectors (2) must engage audibly.
Connect connectors (1) and lock.
The connectors (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
Refer to CONNECTING ALL BATTERY GROUND LEADS .