Removing and installing/replacing backrest for right rear seat (330i xDrive Wagon, 328d xDrive Wagon)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove ARMREST SIDE SECTION .
Unclip REAR SEAT and lay down towards front

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Installation note:

Replace screw (1).

Tightening torque 52 26 1AZ .

Tilt backrest slightly forwards.
Pull backrest forwards and outwards out of center mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The plastic bush (1) may slide during removal of the right backrest.

Make sure plastic bush (1) is fitted correctly in the right backrest frame.

The plastic bush (1) must be retained in the backrest frame.

If applicable, clip the plastic bush (1) in from the outside in.

Necessary preliminary tasks:

Remove ARMREST SIDE SECTION .
Unclip REAR SEAT and lay down towards front

On version with backrest remote unlocking:

Open cover (1).

Feed out bottom Bowden cable (2) from housing (3) and holder (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Installation note:

Replace screw (1).

Tightening torque 52 26 1AZ .

Tilt backrest slightly forwards.
Pull backrest forwards and outwards out of center mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The plastic bush (1) may slide during removal of the right backrest.

Make sure plastic bush (1) is fitted correctly in the right backrest frame.

The plastic bush (1) must be retained in the backrest frame.

If applicable, clip the plastic bush (1) in from the outside in.

Courtesy of BMW OF NORTH AMERICA, INC.