Removing and installing/replacing left (right) capping trim panel (330i xDrive Wagon, 328d xDrive Wagon)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
The operation is described for the left-hand side; proceed in the same way for the right-hand side.
Necessary preliminary work:
- Remove the ROLLER COVER
- Remove load area net
- Fold rear seat backrest forward
- Remove d-pillar TRIM PANEL .
- Remove rear seat BACKREST SIDE SECTION
Release expanding rivet (1) and screws (2).
Release screws (1).
Remove cover (2) and feed seat belt out of trim panel (3).
Raise trim panel (3) slightly and disconnect associated plug connections.
Feed out trim panel (1) on holder (2) for roller cover.
Remove trim (1) in direction of arrow.
Installation note:
Catch (1) and guides (2) of trim panel (3) must not be damaged or missing.