Removing and installing/replacing support for front bumper panel (330i xDrive Wagon, 328d xDrive Wagon)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work
- Remove front BUMPER PANEL .
- Remove IMPACT ABSORBER from support
Version with active pedestrian protection
- Remove right/left (XENON) HEADLIGHT or HEADLIGHT .
A damaged impact absorber must not be reused.
Version with ACC:
Release screws/blind rivet (1).
Installation note:
Blind rivet nuts* and associated screws* are used as repair solution for defective threads or installed blind rivet.
*Sourcing reference, see BMW Group parts sales and distribution/applicable BMW Parts Catalog.
Adhere to the NOTES on mounting blind rivet nuts.
Replacement:
Rework support.
Release screws (1) on left/right.
Tightening torque 51 11 4AZ .
Remove support (2) towards front.