Installing the flange support on the front component carrier

Check 

• Determine the dimension (A) with a standard tool on the flange support (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The dimension (A) on the flange support (1) is 6.4 mm or 7.5 mm.

Measure

• Order the suitable flange supports (1) according to the applicable BMW parts catalogue.

Parts:  Flange union

• Insert and install the flange supports (2).
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Flange connector on component carrier
  M6x20	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the belt pulley (1),
• Replace the bolts (arrows).

  Parts:  Screws

• Hand-tighten the screws (arrows),

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING THE COOLANT LINE BETWEEN THE COOLANT PUMP AND CYLINDER HEAD .
• Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
• Refer to TIGHTENING BELT PULLEY .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE, FRONT .
• Refer to ATTACHING THE ELECTRIC AUXILIARY COOLANT PUMP FOR THE CHARGE AIR COOLER AND/OR AIR CONDITIONING CONDENSER .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING THE CLEAN AIR PIPE WITH THE RESONATOR .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .