Removing the 12V dual storage system
WARNING:
Working on 12V electrical system.
Risk of short circuits! risk of fire!
Risk of short circuits! risk of fire!
- Make sure that there is No charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: detach battery minus cables from all auxiliary batteries.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS
- Refer to IF INSTALLED: REMOVING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
WARNING:
Working on 12V electrical system.
Risk of short circuits! risk of fire!
Risk of short circuits! risk of fire!
- Make sure that there is No charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: detach battery minus cables from all auxiliary batteries.
NOTE:
Technical information
Observe notes on 12V dual storage system.
See further information 6120... NOTES ON 12V DUAL STORAGE SYSTEM .
Observe notes on 12V dual storage system.
See further information 6120... NOTES ON 12V DUAL STORAGE SYSTEM .
- Loosen the detents (1).
- Remove the positive terminal cover (2).
- Loosen nut (3).
- Remove battery rollover protection bracket (4).
- Unlock plug connection (5) and disconnect.
- Loosen nut (1).
- Detach positive battery cable (2) from the positive battery terminal and fix it to the side.
WARNING:
Unprotected battery terminals.
Risk of short circuits! risk of fire!
Risk of short circuits! risk of fire!
- Cover the vehicle battery.
- Open the grab handle and remove 12V dual storage battery (3).