If installed: Removing strut brace in the rear of the engine compartment
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
- Loosen screws (1) and (2).
- Remove strut brace (3).
- Install the strut brace (3).
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATION
Cross-brace to firewall Hexagon screw M10x25
Replace screws.Tightening torque 56 Nm Angle of rotation 90° - Replace screws (2).
Parts: Screws
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATION
| Cross-brace to shock tower | ||
| Hexagon screw M10x55 Replace screws. |
Tightening torque | 56 Nm |
| Angle of rotation | 90° | |